How To Set Up A Spinner Lure

The Spinner Rig has accounted for thousands and thousands of monster carp since its popularity sky rocketed a few years agone. We have had a number of people enquire for a blog post on how to tie the Ronnie Rig and nosotros have asked our resident line-fishing good Wayne Box to evidence you how he does it..... I tend to use the Spinner Rig one of two ways, either with a very stiff boom that I crimp to the hook section or with a more than flexible boom section such every bit a coated braid that I tie using conventional knots. Both take their place merely if there is any debris on the bottom then I will always go for the more flexible hooklink fabric to avoid the rig lifting up off the bottom. Amalgam the Spinner Rig is fairly straightforward only first of all allow's take a look at the components we need:

MATERIALS NEEDED FOR SPINNER RIG

• Hooks
• Spinner swivels
• Kickers
• Hook band swivels
• Hook beads
• Hooklink material
• Crimps and crimping tool if using the Boom cloth.
• Hooklink sleeve
• Bait floss
• Baiting needle
• Hair stop
• Scissors

The items you encounter here are the exact items I use for my rigs but accept a play around and see what components piece of work for you.

Footstep one - Adhere A SPINNER SWIVEL TO THE EYE OF THE HOOK

STEP 2 - SLIDE ON THE KICKER

Cut downward a medium kicker sleeve by nearly 5mm and slide over the middle of the hook wide end first (the thinner end should be closer to the hook point)

STEP 3 - Cover THE HOOK & Swivel

slide the kicker sleeve round the hook until information technology covers the hinge like in the photo

Stride 4 - Apply THE HOOK Ring SWIVEL

Slide a hook ring swivel over the bespeak of the hook followed by a claw bead (I like mine positioned opposite the affront of the hook)

STEP 5 - CUT & Attach BRAID

If using a coated braid for a semi stiff boom, cut off 12 inches of coated braid and thread information technology through the center of the swivel that is attached to the hook.

Pace 6 - TIE ON THE Hinge

Tie the swivel onto the coated braid using an overhand knot, brand sure the loop of the knot is between 1 and two cm in size. Moisten downwardly the knot and trim the tag ends dainty and tight. Many people say that you have to utilize a figure of viii knot here and that's fine but I accept tested this style and never had a knot give mode or slip.

Stride 7 - THREAD A HOOK LINK SLEEVE ON

Thread a hooklink sleeve onto the other terminate of the coated complect and necktie another effigy overhand knot in that end, making certain y'all gear up the length of the rig. Moisten downwardly and trim the tag terminate.

Footstep eight - Apply Claw BAIT WITH BAIT FLOSS

Take a length of bait floss and tie on your called pop up, I like to thread the allurement onto the pilus and secure with a pilus stop, tie off with a couple of granny knots and blob with a lighter.

Stride 9 - ENSURE Bait IS Counterbalanced

Ensure the bait is balanced past adding putty to the knot on the coated braid closest to the claw, yous want the pop up to flutter down and exist simply held on the botto

Step 10 - STEAM THE HOOKLINK

Steam the hooklink straight over a boiling kettle (be conscientious not to burn yourself) and you lot can then attach the rig to your lead setup and away you become! If you have any questions about the Spinner Rig or indeed whatever other carpy related questions then drib me an email [electronic mail protected]

Source: https://www.total-fishing-tackle.com/blog/how-to-tie-the-spinner-rig-total-fishing-rig-school

Share this post